Hitachi Koki C 10FSHC Instrucciones De Seguridad Y Manual De Instrucciones página 32

English
7. Miter cutting procedures
Turntable
Miter scale
Turn the
Indicator
turntable
(For miter scale)
Fig. 30
(4) If the desired miter angle is NOT one of the nine positive stops noted below, please see
the Miter detent override button section on page 21.
(5) Turn the laser guide on and position the workpiece on the table for pre-alignment of
your cut.
CAUTION:
NOTE:
* Positive stops are provided at the right and left of the 0° center setting, at 15°,
22.5°, 31.6° and 45° settings.
Check that the miter scale and the tip of the indicator are properly
aligned.
* Operation of the saw with the miter scale and indicator out of alignment
will result in poor cutting precision.
8. Compound cutting procedures
Compound cutting can be performed by following the instructions in 5 to 7 above. For
maximum dimensions for compound cutting, refer to "SPECIFICATIONS" table on page 12.
CAUTION:
32
Positive stop
lock button
Tighten
Miter lock
handle
Always check that the miter lock handle is secured and the
turntable is clamped.
If you attempt angle cutting without clamping the turntable, then
the turntable might shift unexpectedly causing injuries.
Always secure the workpiece with the right or left hand and cut
it by sliding the round portion of the saw backwards with the left
hand.
It is very dangerous to rotate the turntable to the left during
compound cutting because the saw blade may come into contact
with the hand that is securing the workpiece.
In case of compound cutting (angle + bevel) by left bevel, extend
the sub-fence (B) fully before cutting operation.
In case of compound cutting (angle + bevel) by right bevel, extend
the sub-fence (A) fully before cutting operation.
Please confi rm that sub fence (A) (B) does not interfere with
other parts before attempting compound cutting. If there is any
interference, remove either sub fence (A) or (B).
(1) Unlock the miter table by lifting up on the
miter lock handle.
(2) While pressing down on the positive stop
lock button, grasp the miter lock handle
and rotate the table left or right to the
desired angle.
(3) Once the desired miter angle is achieved,
release the positive stop lock button and
press down on the miter lock handle to
secure the table into position.