Publicidad
Idiomas disponibles
Idiomas disponibles
82
ELECTRIC STARTER
IN COLD:
1.
Open the fuel supply.
2.
Select the ON option on the switch (6).
3.
Place the air inlet in the closed position (right).
4.
Move the accelerator pedal (1) ¼ clockwise from its travel.
5.
Turn the ignition key on the throttle (4) clockwise until the engine starts. Repeat this operation if necessary
until commissioning is completed.
6.
When the engine is switched on, move the air intake to the open position (left).
IN THE HOT
1.
Open the fuel supply.
2.
Select the ON option on the switch (6).
3.
Move the air intake in the open position (left).
Turn the ignition key on the throttle (4) clockwise until the engine starts. Repeat this operation if necessary until
commissioning is completed.
MANUAL START
IN COLD:
1.
Open the fuel supply.
2.
Select the ON option on the switch (6)
3.
Place the air inlet in the closed position (right).
4.
Move the accelerator pedal (1) ¼ clockwise from its travel.
5.
Pull gently on the manual starter until you feel the opposition of the motor, from this point on pull vigorously
until the start is achieved (repeat this operation if necessary).
6.
When the engine is switched on, move the air intake to the open position (left).
IN THE HOT
1.
Open the fuel supply.
2.
Select the ON option on the switch (6).
3.
Move the air intake in the open position (left).
4.
Pull gently on the manual starter until you feel the opposition of the motor, from this point on pull vigorously
until the start is achieved (repeat this operation if necessary).
ENGINE SHUTDOWN
Use the throttle (1) to bring the engine to a minimum speed.
Select the OFF option on the switch (6) and turn the ignition key to the original position (4) in case of electric ignition.
If starting was manual, just select the OFF option on the switch (6).
Close the fuel valve.
SAFETY FEATURE
In order to guarantee the operator maximum working safety, the machine is equipped with the following safety device:
-
Reverse gear engagement control cam; releasing the cam automatically disengages the reverse gear.
ATTENTION: Do not use the machine if the safety device is not working properly for any reason to
avoid damaging the safety device
Publicidad
