Foppapedretti TicToc Manual De Instrucciones página 27

UNFOLD THE STROLLER
CAUTION: make sure that the child, and any other children, are at a safe distance
away when carrying out this step.
The moving parts of the stroller must not for any reason come into contact with the child's body.
FRAME OPENING (fig. 1. 2, 3, 4)
Press the folding lock button "a".
Press the button "b" (1) and extend the handlebar until its opens completely (2).
Lift the handlebar until the chassis opens completely. A click will indicate that is has been fastened (fig. 2).
Rotate the seat support to the horizontal position, as shown in the figure. A click will indicate that is has been fastened
(fig. 4).
CAUTION: before use, make sure that all the locking mechanisms are correctly engaged.
INSTALL FRONT WHEELS (fig. 5)
Right wheel (R): Insert the end bushing into the slot situated in the center of the wheel block, , with the locking lever
facing outwards . A click will indicate that it is inserted correctly.
Left wheel (L): Insert the end bushing into the slot situated in the center of the wheel block, , with the locking lever facing
outwards. A click will indicate that it is inserted correctly.
Check that both the wheels have been fastened correctly, if they are pulled downwards they should not be released.
Removing the front wheels (fig. 6): Press the steel button "b" front wheel released.
REAR WHEELS
Fitting the rear wheels (fig. 7): Insert the wheel pin in the hole, a click will indicate it has been fastened in place. Make sure
that the wheel has been secured correctly, it should not come away when it is pulled outwards.
Removing the rear wheels (fig. 8): Pull the metal lever "a" on the wheel hub and, at the same time, remove the wheel.
FASTENING THE SEAT (for use as a pushchair)
Fitting the seat (fig. 9, 10): to fit the seat, place it in the position shown in the figure 22. Line up and insert the plastic
connectors
of the seat in the slots provided on the pushchair chassis. Press until a click is heard indicating that it has been fastened
correctly.
WARNING: Before use, always check that both the seat supports are fastened correctly to the chassis. When the seat is
lifted upwards, it must not detach from the chassis.
Removing the seat (fig. 11): press button "a" on both sides and remove the seat by lifting it.
REVERSIBLE SEAT (fig. 12)
Remove the seat by lifting it, see the paragraph "Install the seat".
Position the seat so that it is forward facing or parent-facing.
Replace the seat on the chassis of the pushchair, see the paragraph "fitting the seat" for correct assembly.
FITTING THE BUMPER BAR
Fitting the bumper bar (fig. 13, 14, 15): lift up the two attachment points for the handlebar, a CLICK will indicate that
they are locked. Line the bumper bar up with the slots and press on both sides. A click indicates that it has been fastened
correctly.
Removing the bumper bar (fig. 16): press button "a" on both sides of the bumper bar and at the same time pull to remove
it.
Opening the bumper bar on just one side (fig. 17): press button "a" on one side of the bumper bar and pull to open it
like a gate.
IMPORTANT: when the stroller is in use, the armrest must always be used and locked in position; if the armrest is removed,
check that the armrest supports are lifted up and locked properly in the vertical position.
• ENGLISH •
ASSEMBLY
27