1. SELECT BLOWER OPTION
AND INSTALL DUCTWORK
Either an interior or exterior blower may be used with this hood.
The RM60000 Series hood must be installed with blower models
RM325H, RM326H, 331H, 332H, 335 or 336 only. Other blowers
cannot be substituted. (Blowers sold separately).
NOTES:I.
The 331 H, 332H, 335 or 336 exterior blower MUST
BE installed with the rough-in kit model 332KR (sold
separately).
2. in addition to the blower models listed above, this hood
is also compatible with older internal blower versions
325H and 326H. However, discard the installation
instructions
included with those blowers and contact
our technical suppport to obtain replacement instruction.
Plan where and how the ductwork will be located.
install proper-sized ductwork, transition(s), elbow(s), and roof or
wail cap for the type of blower you are using.
711(178
mm)
MODEL RM328H SINGLE BLOWER
TYPICAL DUCTWORK
ROOFCAP
\
le'(254
mm)
ROUND
DUCT
(114 x470to
(see
page
4)
f
MODEL RM326H DUAL BLOWER
TYPICAL DUCTWORK
10" (254 mill)
10" (254 mm)
BLOWER
HH0026A
MODEL 331H, 332H, 338 OR 338 EXT.
BLOWERTYPICAL DUCTWORK
2. MEASURE INSTALLATION
Dimensions for the most common installations are shown
below.
Adjust your measurements for various heights of ceilings, soffits,
cabinets or cooktops. For proper operation, the hood must be a
minimum
of 24" and a maximum
of 30" above the cooktop.
Standard 18"
18"
(457 rnm) H
(457 ram)
over'c0okto9
19"
cabinet
(483 ram)
Top of wood
mounting
strip
RMR Series
--_
BackspUash
(optiona0
24"
({}10 ram)
Minimum
distance
between
the
hood
and the eooktop
--
Starldard
36"
(914 ram}
Cooktop
H cooktop
HHOO2SA
INSTALLATION WITH STANDARD
!8" HIGH
OVER-COOKTOP
CABINET
Stasdard
8 ft. (2,44 m)
ceiling
(33
ram)
\
Top of wood
X
mounting
strip
Hood
._
RNP Series
_-
IBacksplash
(optional)
30"
Maximum
distance
(762 tara)
between
the hood
and the cooktop
'1--
Standard
36"
Cooktop
m
(914 tara) H
j
cooktop
NH0027A
INSTALLATION WITH !2" SOFFIT OR
OPTIONAL
SOFFIT CHIMNEY
RMN SERIES
_5 _