Broan-NuTone RANGEMASTER RM60000 Serie Manual De Instalación Y Utilizacion página 6

3. PREPARETHE INSTALLATION
Remove the installation kit from inside the hood.
Make sure that the fotlowing items are included:
+Wood strip
4nstallation manual
+Accessories including:
+Filters (Quantity varies depending on range hood width)
+Bag of parts inciud+ng:
Screws #10-2" flat head (4),Screws #8-3/4" (8), Nuts #10-32 (4)
Wail anchors (2), Washers 3/16" ID X 3/4" OD (2)
Using a Phillips #2 or a Robertson #2 screwdriver, unscrew the hood
from the bottom of crate. Refer to figure beside to locate all 4 screws.
Discard these screws and remove hood from wood pallet.
HR0002
4. INSTALL BACKSPLASH
(OPTIONAL) RMP Serfes
Backsplash must be installed before the hood shelI because the hood shelI covers the backspIash top mounting screws. In order to be
able to install the backsplash, make sure you have at least 18" (457 mm) clearance between bottom of hood and range control panel or
cooktop. (Refer to instructions included with backsplash.)
5. INSTALL WOOD MOUNTING STRIP
Measure and mark a level line on waiI above cooktop Iocation for the wood
mounting strip (see iilustration below and under step 2)+ Use #10 - 2" flat
head screws to secure the mounting strip to the drywall Make sure to
hit the wall studs. (See figure beside.)
6. INSTALLTHE HOOD
®
®
®
HDOO68A
1. Drywall
2. Wood Mounting Stnp
3 Flat Head Screw
13" (330 mm) or
19" (483 ram) from
ceiiing (see page 5)
(38 ram)
Rest the back cavity of the hood on the wood mounting strip.
4 [A/allAnchor Location
5. Outline of the Back of the Hood
6. Wall Studs
Secure hood to wood strip with (4) screws #8 - 3/4" (for 30" and 36"
width hoods) or (6) screws (for 42" width and wider hoods) provided at
locations shown. Drill (2) 3/16" size holes into the drywall for wall
anchors through the existing hoies in the inside hood back in the loca-
tions shown. Then instaiI the two walI anchors and attach the hood to
these anchors with the remaining #8 + 3/4" screws and the (2) washers
provided.