Rubi DC-250 PYTHON Instrucciones Originales página 13

FAILURE
The motor does not start
The motor starts but turns in
reverse or does not understand
the direction of rotation.
Motor overheats or stops.
Motor stops when cutting
Misaligned cuts
Blade closes easily
Blade wears easily
Blade cuts hard or very slow
Machine generates vibrations
POTENTIAL CAUSE
No power supplied or insufficient supply to motor.
Locked motor.
Switch issue.
Motor issue.
Defective capacitor.
Motor issue.
Cable extension is insufficient or defective.
Overloading.
Inappropriate power supplied.
Speed of cut is too fast.
Motor issue.
Blade nearing end of optimum performance.
Overloading.
Lack of power in the motor.
Motor issue.
Blade is nearing end of optimum performance.
Inappropriate blade for the material
Movement when cutting
Machine is placed on an uneven surface
Machine is misaligned
Material to cut is too low abrasive for that
particular blade
Cutting speed is too fast.
Inappropriate cooling of the blade
Material is too thick
Material is very abrasive
Inappropriate blade for the material
Blade is nearing end of optimum performance.
Lack of power in the motor.
Oscilations of the blade.
Defective flanges.
· TRANSLATION OF THE ORIGINAL · ENGLISH
SOLUTION
Check installation and electric cable.
Check motor's rotation without load.
Replace switch. Contact After Sales Service.
Replace motor. Contact After Sales Service.
Replace capacitor. Contact After Sales Service.
Replace motor. Contact After Sales Service.
"Check cable extension is suitable.
Plug the machine directly to supply."
Reduce working load.
Check tension.
Reduce speed of cut.
Replace engine. Contact After Sales Service.
Check blade. Replace blade
Reduce working load.
Check voltage input to the machine. Check engine condition.
Replace motor. Contact After Sales Service.
Check blade. Replace blade
Use a different recommended blade.
Fix material properly with the relevant accessories.
Using a spirit level place the machine level on the working surface.
Check machine's alignment. Use alignment tool to re-adjust. Contact After
Sales Service.
Use a softer rim blade.
Reduce speed of cut.
Check water pump, pipes and flow control system.
Use appropriate blade type for that thickness.
Use a harder rim blade.
Use a harder rim blade.
Check blade. Replace blade.
Check voltage input to the machine. Check motor condition.
Check the blade. Replace the blade.
Check flanges. Replace flanges.
EN
- 13 -