Publicidad
Idiomas disponibles
Idiomas disponibles
o
vervieW of controL PaneL
On / Off button:
Enables you to switch the electrolyser on or off
Functioning, the LED is green. Not in function, the LED is red.
Lack of salt indicator:
Enables to know if salt level is correct.
If level is correct, the LED is green. Otherwise the LED is red. In this case, test the water and
add or remove salt (see "Required salt levels", page 30).
2-digit display:
Visually displays different informations:
Mode selection button
Press repeatedly to change the operating mode by increments.
During chlorine production, the green LEDs correspond to
the mode selected
Production in progress indicator,
shown here in summer mode
The button for setting reverse polarity time
Use to set the polarity inversion time to 4h / 8h or 12h, depending on the hardness of your water. As
water hardness increases, the time should decrease (400 ppm => 4h and 10 ppm =>12h).
USING THE CONTROL PANEL
•
Chlorinator status: OFF when switched off
•
The water temperature, for ease of setting; this is the default display when the chlorinator
is running.
•
The selected mode, which changes each time the mode selection button is pressed:
CO: Covered pool mode
P4: Spring mode
P6: Summer mode
On/Off button
2 digits Indicators
Mode selection button
Reverse polarity time selection button
Lack of salt indicator
Operating modes indicator
P8: Comfort mode
B1: BOOST 1 Mode
B2: BOOST 2 Mode
Once the daily production cycle is complets or if
the chlorinator is switched off, the 25% LED will
be red.
OFF indicator
|
EN
33
Publicidad
