Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE CONTROL PANEL
s
eLecting oPerating modes
IMPORTANT: The chlorinator will only function when water flow is detected, i.e., when
the filtration system is switched on. Filtration time must therefore be sufficiently
long for the selected operating mode (preferably one time slot per day during
periods of strong sunlight).
Reminder: use the following formula to determine the best setting: Filtration lime = (T° water)/2
1- Covered Pool Mode (or off-season)
Chlorine production must be reduced if your pool remains covered for prolonged periods to avoid
overproduction. Covered pools are less exposed to organic materials (bacteria, cells), UV rays and other
sources of light. As a result, hypochlorite recomposes into salt more slowly in an indoor pool.
Overproduction can lead to increased corrosion of the exposed metal surfaces of your pool.
Select the Covered Pool (CO) mode when you cover your pool for more than 3 days, and in the
off-season, when the water temperature is above 10°C but not above 20°C. The chlorinator will
only produce for 2 hours a day.
2 - Spring mode
At the start of the season, when water temperatures are higher than 20°C, but do not exceed
25°C (i.e. a recommended filtration time of between 10h and 12h), select Spring mode (P4). The
chlorinator will produce chlorine for 4 hours per day. Below 10°C, the chlorinator will not function
and will display the following error code: E7.
3 - Summer mode
During the regular season, when water temperatures are higher than 25°C, but do not exceed
28°C (i.e., a recommended filtration time of between 12h and 16h), select Summer mode (P6).
The chlorinator will produce chlorine for 6 hours per day.
4 - Comfort mode
During the peak of the season, or if you heat your pool, when water temperatures are higher than
28°C (i.e., a recommended filtration time of between 16h and 24h), select the Comfort mode (P8).
The chlorinator will produce chlorine for 8 hours per day.
5 - BOOST 1 Mode
Above these temperatures, during periods of hot weather with water temperature exceeding 30°C
(i.e., a recommended filtration time of 24h), or following heavy rainfall, it may be necessary to
increase hypochlorite production for a limited period of time.
Select BOOST 1 mode (B1). The chlorinator will produce chlorine for 12 hours per day.
6 - BOOST 2 Mode
During periods of extremely hot weather, with water temperatures exceeding 30°C (i.e., a
recommended filtration time of 24h), and/or with intensive use of the pool, it may be necessary
to produce even more chlorine for a limited period of time. Select BOOST 2 mode (B2). The
chlorinator will produce chlorine for 24h over the course of the day and revert to Comfort Mode
(PB) the following day.
These are preset modes and will restart daily at their selected time. Depending on the
usage and conditions of your pool (volume, exposure to plant material, sunlight, etc.),
it may be necessary switch to a higher or lower mode. We recommend that you select
your preferred mode at around 8 am.
|
34
EN
Publicidad
