Harbor Breeze LOCHWOOD Manual Del Usuario página 8

FAN INSTALLATION
1. Remove the canopy bottom cover (C) from
the canopy (B) by turning the canopy bottom
cover (C) counterclockwise.
Remove the mounting bracket (A) from the
canopy (B) by loosening canopy mounting
screws a half turn from the screw head.
Next, turn the canopy (B) counterclockwise
to remove the mounting bracket (A) from the
canopy (B).
2. Secure mounting bracket (A) to outlet box
(not included) using screws, lock washers
and flat washers provided with the outlet box.
NOTE: It is very important you use the proper
hardware when installing the mounting bracket (A)
as this will support the fan.
IMPORTANT: If using the angle mount, make
sure open end of mounting bracket (A) is installed
facing the higher point of the ceiling.
3. Remove the cotter pin and clevis pin , and
loosen the two collar set screws from the
fan motor assembly collar.
1
Canopy Mounting
Screw
2
3
Cotter Pin
Set Screw
8
Canopy Mounting
Screw
Lock Washers
Flat Washers
Outlet Box
Screws
Collar
Set Screw
Clevis
Pin