WEG CFW500 Serie Manual Del Usuario página 33

Seq Indication on the Display / Action
11
If necessary, modify the content of "P0403 –
„
Motor rated frequency", or press the Key  for
the next parameter.
12
If necessary, modify the content of "P0404 –
„
Motor rated power", or press the key  for the
next parameter.
13
If necessary, modify the content of "P0407 –
„
Motor rated power factor", or press the key 
for the next parameter.
14
At this point, the HMI shows the option to do the
„
self-adjustment. Whenever possible, perform
the self-adjustment. Thus, to activate the self-
adjustment, change the value of P0408 to "1".
15
During the Self-Adjustment the HMI will
„
simultaneously indicate the status of "RUN"
and "CONF". And the bar graph indicates the
progress of the operation.
And the bar graph indicates the progress of
„
the operation. The Self-Adjustment can be
interrupted at any time by means of the key
Figure 5.3 (cont.): Sequence of the Startup group for V V W control
Seq Indication on the Display / Action
16
At the end of the Self-Adjustment, the value
„
of P0408 automatically returns to "0", as
well as the Status of "RUN" and "CONF"
are cleared.
Press the key  for the next parameter.
„
17
The result of Self-Adjustment is the value
„
in ohms of the motor stator resistance
shown in P0409.
This is the last parameter of the Self-
„
Adjustment of the V V W control mode.
Press the key  to return to initial
parameter P0202.
18
To exit the STARTUP menu, just press
„
BACK/ESC.
19
Through the keys  and , select the
„
desired menu or press the key BACK/ESC
again to return directly to the monitoring
mode of the HMI.
.
- English -
Powering up and Startup
CFW500 | 27