GE Quick Set V Manual Del Propietário página 46

Before You Call For Service...
Troubleshooting Tips
Possible Causes What
To Do
Clock and timer do Plugon range is not completely • Hake sure electrical plug is plugged into a live, properly
not work inserted in the electrical outlet, grounded outlet.
A fuse in your home • Replacethe fuse or reset the circuit breaker.
may be blown or the
circuit breaker tripped.
Oven controls improperly set. • See the Using the kitchen timer section.
Ovenwill not self-clean The oven temperature is • Allow the range to cool and reset the controls.
too high to set a self-clean
operation.
Oven controlsimproperly set. • See the Using the self-cleaning upper and lower ovens
section.
The probe is plugged into • Remove the probe from the oven.
the outlet in the oven.
ion some modelsl
"Crackling" or This is the sound of the • This is normal.
"popping'sound metal heating and cooling
during both the cooking and
cleaning functions.
Excessivesmoking Excessivesoil. • Touch the CLEAR/OFFpad. Open the windows to
during a clean cycle rid the room of smoke. Wait until LOCKED/DOOR
goes off. After the oven cools, wipe up the excess soil
and reset the clean cycle.
Oven door willnot Oven too hot. • Allow the oven to cool below locking temperature.
openafter a cleancycle
Oven not clean after a Oven controls not properly set. * See the Using the self-cleaning upper and lower ovens
clean cycle section.
Oven was heavily soiled. * Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
"LOCKED" flashes The self-clean cycle has been • Close the oven door.
in the display selected but the door is not
closed.
"LOCKED" is on The oven door is locked • Touch the CLEAR/OFFpad. Allow the oven to cool.
when you wont because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
"F-"andanumber You have a function error code. • Disconnect all power to the range for at least
or letter flash 30 seconds and then reconnect power. If the function
in the display error code repeats, coil for service.
46