GE Quick Set V Manual Del Propietário página 38

Care and cleaning of the range.
Oven
frame
Door
Lift-Off Upper Oven Door Ion somemodels)
To remove the door:
To replace the door:
r_ Fully open the door.
[] Lift up on the hinge lock toward the
oven frame until they stop.
[] Close the door to 45 degrees (you will
feel the door stop).The hinge lock will
contact the oven frame.
[] On both sides of the door, press down
on the release buttons on each hinge.
[] Lift door up until it is clear of the hinge.
161 Pullon hinge arms slightly to relieve
pressure on the locking tabs.
[Z] Pushthe hinge locks down onto
the hinge.
[] Pushthe hinges in toward the unit
so they are closed.
r-_ Pullthe hinges down away from the
oven frame to the fully open position.
Lift up on the hinge lockstoward
the oven frame until they stop.
The hinges will releaseto the
45-degree position.The hinge locks
will contact the oven frame.
Slide the door back onto the hinges.
Make sure the buttons pop back out.
Fully open the door.
[] Pushthe hinge locks down onto
the hinge.
[Z] Close the oven door.
Oven Racks
Ftatrack
Handles
Usethe rack with the two front handles
in the upper oven.
Usethe rack without the two front
handlesin the lower oven.
All oven racks may be cleaned by hand
with an abrasive cleaner or steel wool. After
cleaning, rinse the racks with clean water
and dry with a clean cloth. Grog porcelain-
coated oven rocks may remain in the oven
during the self-cleaning cycle without being
damaged. The nickel-plated oven racks
may remain in the oven during the
self-cleaning cycle, but they will losetheir
luster and become hard to slide. It will be
necessary to grease all oven rack side
edges with a light coating of vegetable oil
after cleaning them bg hand or in the oven.
This will help maintain the ease of sliding
the rocks in and out of the oven.
38