GE Quick Set V Manual Del Propietário página 42

Cleaningthe glass cooktop. Con some mode/s;
Clean yourcooktopafter
each spill. Use CERAMA
BRYTE ® CeramicCooktop
Cleaner.
Normal Daily Use Cleaning
ONAW use CERAMA BRYTE ®Ceramic
Cooktop Cleaneron the glass cooktop.
Other creams may not be as effective.
To maintain and protect the surface of
your glass cooktop, follow these steps:
Before using the cooktop for the
first time, clean it with CERANA
BRYTE ® Ceramic Cooktop Cleaner.
This helps protect the top and makes
cleanup easier.
[] Daily use of CERANABRYTE ®Ceramic
Cooktop Cleaner will help keep the
cooktop looking new.
[]
%
Shakethe cleaning cream well.
Apply a few drops of CERAMA BRYTE ®
Ceramic Cooktop Cleaner directly
to the cooktop.
Usea paper towel or CERAMA
BRYTE ® Cleaning Pad for Ceramic
Cooktops to clean the entire cooktop
surface.
r_ use a dry cloth or paper towel
to remove all cleaning residue.
No need to rinse.
NOTE: It is verF important that Fou DO
NOT heat the cooktop until it has been
cleaned thoroughlF.
Usea CEFIAMA BFIYTE ® CleaningPadfor
CeramicCo@tops.
Burned-On Residue
NOTE: DAMAGEto Four glass surface
roof occur if Fou use scrub pads other
than those recommended.
I-7-1 Allow the cooktop to cool.
[] Spread a few drops of CERAIA
BRYTE ®Ceramic Cooktop Cleaner on
the entire burned residue area.
[]
Using the included CERANABRYTE ®
Cleaning Padfor Ceramic Cooktops,
rub the residue area, applying
pressure as needed.
%
If any residue remains, repeat
the steps listed above as needed.
For additional protection, after all
residue has been removed, polish
the entire surface with CERAMA
BRYTE ®Ceramic Cooktop Cleaner
and a paper towel.
The CEFIAMA BRYTE ® CeramicCo@top
Scraperand all recommended supplies
are availablethrough our PartsCenter.
Seeinstructionsunder"To OrderParts"
section on next page.
NOTE:Bo not use a dull or
nicked blade.
Heavy, Burned-On Residue
ryl
[]
Allow the cooktop to cool.
Use a single-edge razor blade
scraper at approximately a 45 °
angle against the glass surface and
scrape the soil. It will be necessary
to apply pressure to the razor
scraper in order to remove
the residue.
@
After scraping with the razor
scraper, spread a few drops of
CERAMA BRYTE ®Ceramic Cooktop
Cleaneron the entire burned residue
area. Use the CERAMABRYTE ®
Cleaning Pad to remove any
remaining residue.
[]
For additional protection, after all
residue has been removed, polish
the entire surface with CERAMA
BRYTE ® Ceramic Cooktop Cleaner
and a paper towel.
z_2