Kingfisher CLCG60LKSS Manual Del Usuario página 71

EN Use
Before you start
WARNING: Read the instructions before using the appliance.
Switch on the Residual Current Device (RCD) at the consumer unit. The appliance is ready for use.
EN Functions & Settings
01 Control panel
To obtain the best results from your cooker hood it is recommended that you leave it switched on for up to 15
minutes after you have finished cooking.
1
1. Light On/Off
2. Fan On/Off and Speed Reduction
3. LED Display
To Set Up For First Use
IMPORTANT: Complete this set up within two minutes of turning on the
Residual Current Device (RCD).
Ducted Option This is the factory default setting if you are extracting air to the outside.
Recirculation Option
To change to this option, press both Speed icons
Speed Increase to change to the Recirculation Option
Ducted Option . Finally, press both Speed icons
the Timer will stop flashing.
02 General Use
Light On/Off
• Use this control to switch the light on independently of the fan motor, it will be lit red in this mode.
• When the fan is in use, and the light is off, the icon will be lit white in this mode, but will turn red if the
light is then switched on.
Fan On/Off and Speed Reduction
• Press this icon once to turn on the fan motor at speed 1. All icons will be white and the light icon will be
red if already in use.
5059340446103_MNL_IN_V04.indb 70 5059340446103_MNL_IN_V04.indb 70
2
This is the option to be used with carbon filters.
3 4
4. Boost Function and Speed Increase
5. Timer
together and the Timer
and the Speed Reduction
together one more time to confirm the change and
70
5
will flash red. Press the
to revert back to the
8/6/2022 3:47 PM 8/6/2022 3:47 PM