Beurer EM 49 Instrucciones De Uso página 19

10. Customizable Programs
(TENS programs 13-15, EMS programs 33-35)
TENS programs 13-15 and EMS programs 33-35 can be customized according to your needs.
TENS 13
In this program, you can set the impulse frequency between 1 and 150 Hz and the impulse width between 80 and 250
μs.
1. Place the electrodes on the desired area for treatment (for placement suggestions see the 'Electrode Positioning' section) and
connect them to the device.
2. Select the TENS 13 program as described in the 'Starting Application' section, steps 3-5.
˄/˅
3. Use the setting buttons to select an impulse frequency and use the ENTER button to confirm.
˄/˅
4. Use the setting buttons to select an impulse width and use the ENTER button to confirm.
˄/˅
5. Use the setting buttons to select a treatment time and use the ENTER button to confirm.
˄/˅
6. Use the left and right
TENS 14
Various impulse sequences run in this burst program. Burst programs are suitable for all areas of application to be treated with
changing signal patterns (to minimize the level of accustoming to the treatment). In this program, you can set an impulse width
between 80 and 250 μs.
1. Place the electrodes on the desired area for treatment (for placement suggestions see the 'Electrode Positioning' section) and
connect them to the device.
2. Select the TENS 14 program as described in the 'Starting Application' section, steps 3-5.
˄/˅
3. Use the setting buttons to select an impulse width and use the ENTER button to confirm.
˄/˅
4. Use the setting buttons to select a treatment time and use the ENTER button to confirm.
˄/˅
5. Use the left and right
TENS 15
In this program, you can set the impulse frequency between 1 and 150 Hz. The impulse width changes during the stimulation
treatment.
setting buttons for and
setting buttons for and
to select an impulse intensity.
to select an impulse intensity.
19