Beurer EM 49 Instrucciones De Uso página 25

(4) Check electrode positions and ensure that adhesive electrodes do not overlap.
(5) Gradually increase the impulse intensity.
(6) The batteries are almost empty. Replace the batteries.
The low battery symbol is shown.
Replace all batteries.
You have an unpleasant sensation at the electrodes.
(1) The electrodes are not positioned correctly. Check their positions and re-position, if necessary.
(2) The electrodes are worn. This may cause irritated skin as even distribution of the current across the entire area is no longer
guaranteed. For this reason, replace the electrodes.
Skin in the treatment area turns red.
Immediately stop treatment and wait until your skin has returned to its normal condition. If the redness is under the electrode and
disappears quickly, there is no risk, as this is caused by the locally stimulated, increased blood flow. Consult your doctor, however,
before you continue treatment if the skin irritation persists and is accompanied by an itchy sensation or inflammation since this may
be caused by an allergic reaction to the adhesive surface.
15. Specifications
Model:
Type:
Output waveform
Pulse length
Pulse frequency
Output voltage max.
Output current max.
Voltage supply
Treatment time
Intensity
Operating conditions
Storage conditions
EM 49
EM 49-2
Biphasic rectangular pulse
50 - 450 μs
1 - 150 Hz
100 Vpp (500 ohm)
200 mApp (500 ohm)
3 AAA batteries
Adjustable from 5 to 100 minutes
Adjustable from 0 to 50
41° - 104° F (5° - 40° C) at a relative humidity of 15 - 90%
32° - 104°F (0°C - 40°C) at a relative humidity of 0 - 90%
25