Publicidad
Idiomas disponibles
Idiomas disponibles
4 CONFIGURATION OF THE CONTROL PANEL
The universal control unit NET24N can be used for the management of the following types (
stem: swing and sliding gates, overhead doors and barriers.
In order to ensure maximum adaptability to each
fi rst turn, for the optimal confi guration of inputs, outputs and parameters (see diagram
in the mode "dedicated" to the
programming for the installation on which it is operating.
All settings remain in memory even in the case of subsequent fl are-ups (see diagram
If necessary the
FIRST CONTROL BOARD IGNITION
Confi guration after the fi rst ignition
For the fi rst control panel ignition, proceed as fol-
lows:
1. Apply power, the display shows in sequence the
writing "
" and "
2. Press the
button and hold for 5 seconds until
the display shows
3. Acting on the
confi guration depending on the type of installa-
tion (es.
) and confi rm by pressing the
button;
At this point, the selection will be stored and relo-
aded each time in the future.
4. Follow signs, "
symbol of closed gate "- - - - ".
Following ignitions
If you have already saved a confi guration, pro-
ceed as follows:
Apply power, the display shows in sequence the
writing "
", "
symbol of closed gate "- - - - ".
Modify the existing confi guration
If you have already saved a confi guration and you
want to change it, proceed as follows:
1. Hold down the
splay shows in sequence the writing "
"
" fl ashing;
2. Press the
button and hold for 5 seconds until
the display shows
match the previous confi guration used) on the
display;
3. Acting on the
confi guration depending on the type of installa-
tion (es.
) and confi rm by pressing the
button;
Stop the reconfi guration procedure prior
to confi rmation, involves loading the previous
confi guration by the control panel without any
modifi cation.
However, if the reconfi guration procedure is
brought to an end, the new confi guration will
take the place of the previous one and will be
reloaded each time in the future.
4. Follow signs, "
symbol of closed gate "- - - - ".
EN-4
of selected closing. After performing the initial confi guration it is suffi cient to execute the standard
of confi gured closing can be later adjusted following diagram
" fl ashing;
on the display;
and
keys, select the desired
", "
" followed by the
", "
" followed by the
button and give power, the di-
" and
(the value changes to
and
, select the new desired
", "
" followed by the
of closure, the control board provides an initial procedure, performed only at the
) of closures motorized by DEA Sy-
). Once confi gured, the control panel will operate
).
.
Sliding gates
Swing gates
Overhead doors
Barriers
Publicidad
