Control; Starting The Chiller - Parker Hiross Hyperchill ICE001 Manual De Uso

4

Control

4.1 Control panel
S1
H1
L1 P2
A1
L2
P1 SET key: used to access parameter
programming functions.
P2 UP key: used to increase the value of a
parameter.
P3 DOWN key: used to decrease the value of a
parameter.
S1 On/Off switch: enables pump startup and
activates the control
L1: green Indicates compressor operation
L2: green Not utilised
L3: red Indicates presence of controller alarms
H1: red Indicates the presence of machine alarms.
English
4.2

Starting the chiller

S Switch on the chiller as follows: press the On/Off [S1] switch
to On.
S Set the desired temperature on the controller.
4.3 Stopping the chiller
When chiller operation is no longer required, turn the chiller off
as follows: turn the On/Off [S1] switch to Off.
4.4 Parameter settings
General
There are two levels of parameter protection:
a) Direct (F): with immediate access;
b) Password (C): with password controlled access;
P1 L3
set
P3
4.4.1 Chiller parameters
PARAMETER CODE
Serial address
H0
C parameters password PA
4.4.2 Sensor parameters
PARAMETER CODE
Unit of measurement selection /5
4.4.3 Regulator parameters
PARAMETER CODE
Control differential
rd
(hysteresis 0=0.5 ˚C/˚F).
4.4.4 Compressor parameters
PARAMETER CODE
Compressor start delay on ap-
C0
pliance switch on [min.].
Minimum time period between two
successive compressor start ups
C1
[min.].
Minimum compressor 'Off' time
C2
[min.].
Minimum compressor 'On' time
C3
[min.].
Hyperchill (ICE001)
TYPE DEFAULT
C
1
C 22
TYPE DEFAULT
C 0
TYPE DEFAULT
F 2
TYPE DEFAULT
C
0
C
6
C 0
C
0
11