Publicidad
Idiomas disponibles
Idiomas disponibles
– Adjusting the distance between the HANDBIKE BATEC HIBRID and
the wheelchair.
– Adjusting the angle of the stem on the HANDBIKE BATEC HIBRID.
– Adjusting the height of the handlebar on the HANDBIKE BATEC
HIBRID.
5.2.1. ADJUST THE DISTANCE BETWEEN THE HANDBIKE BATEC HIBRID
AND THE CHAIR
With the HANDBIKE BATEC HIBRID anchored, adjust the distance be-
tween the HANDBIKE BATEC HIBRID and the wheelchair so that there
is as little space as possible between the user's feet and the stand
frame, using the telescopic anchoring bar and the screws indicated. If
the user doesn't have any other preference or limitations, we recom-
mend a distance of 8 cm.
(See fig. 32)
5.2.2. ADJUST STEM ANGLE
With the HANDBIKE BATEC HIBRID anchored, adjust the angle of the
stem on the HANDBIKE BATEC HIBRID in order to fit the handlebar
to the user's arm length, using the screws indicated. The upper and
lower screws must be set on the same number. If the user doesn't
have any other preference or limitations, we recommend position 3.
(See fig. 33)
5.2.3. ADJUST STEM HEIGHT
With the HANDBIKE BATEC HIBRID anchored, adjust the stem height
on the HANDBIKE BATEC HIBRID with the Quick Release lever.
5.2.4. LCD CONSOLE ADJUSTMENTS
1. Switch on the battery to see the INFORMATION SCREEN.
2. Press M (mode) button to move between all functions in loop se-
quence from one function screen to another as CLOCK / ODO
– 36 –
(odometer) - RT (partial time) / TT (total time) - AVG (average speed)
/ MAX (maximum speed) - TRIP 1 / ODO - TRIP 2 / ODO.
– Press R (reset) button for 2 seconds to reset TRIP 2, AVG and MAX
– Data of TRIP 1, AVG and RT can be reset at the same time when
– ODO, CLOCK and TT data cannot be reset.
3. Press M and R buttons simultaneously for 2 seconds to display the
SETTING SCREEN 1.
4. Press M button to move between all functions in loop sequence
from one function screen to another as 12/24 hour, clock, circum-
ference wheel number and Km/h or MPH.
– Press R button to increment the flashing digit by 1 or convert units.
– Press M button to confirm the digit setting and jump to next digit
– The c (circumference number) values are those:
– Press M for 2 seconds at any setting screen to finish the setting
5. On SETTING SCREEN 1 (step 4) pressing M and R buttons simulta-
neously for 2 seconds will display the SETTING SCREEN 2.
– Battery voltage value is on the bottom and manufacturer fine ad-
6. To return to INFORMATION SCREEN and fix all settings press M but-
ton for 2 seconds, if the screen displays SETTING SCREEN 1 press M
(See fig. 34)
button for 2 seconds again.
(See fig. 35)
from stored values to zero individually.
one of the three data functions is being reset.
(See fig. 37)
or next setting screen to be set.
HANDBIKE BATEC HIBRID HIBRID 2: 947
and go to INFORMATION SCREEN
justment battery value is on top.
(See fig. 39)
– 37 –
(See fig. 36)
(See fig. 38)
Publicidad
