Publicidad
Idiomas disponibles
Idiomas disponibles
1
Main Handle is used to raise and lower the head as-
sembly and contains the power switch. Pull the handle
down to lower the blade to the workpiece.
2
Switch Lock-OFF Release Buttons two buttons, one
of which must be pressed before the power switch can
be pressed.
3
Power Switch is used with the "Lock-OFF" button to
turn the saw off and on.
4
Main Carry Handle is used to carry the saw.
5
Lower Guard Link allows for smooth movement of the
lower guard.
6
Dust Chute directs sawdust up into the dust bag or
vacuum hose.
7
Slide Rail Lock Knob when tightened, locks the slide
system in place. Tighten by turning the knob clockwise
(to the right), and loosen my turning counterclockwise
(to the left).
8
Head Assembly Lock Pin is used to lock the head
assembly in the lower position.
9
Bevel Post provides rotating support for all of the
miter saw parts above the table.
10
Bevel Scale and Pointers indicates the current bevel
angle. The large angled scale makes it easy to read
bevel angles.
11
Bevel Range Selector Knob is used to select the bevel
range: 0° to 47° left or 0° to 47° right.
12
Sliding Fences support the workpiece. The fences
have a cast-in scale to make repetitive cuts easy and
have holes to secure an auxiliary fence if required.
13
Tool Mounting Pads in the four corners of the saw
provide areas to clamp, bolt, or nail the saw to a flat
work surface.
14
Cast-in Carry Handles are used to lift and transport
the saw.
15
Stationary Fence is bolted to the base and supports
the workpiece when the sliding fence is removed.
16
Base Extensions provide extra support for the saw,
which can be useful when cutting long workpieces.
Getting to Know Your Miter Saw
17
18
19
20
21
22
23
24
25
26
27
-11-
Miter Detent Plate can be adjusted to set the ac-
curacy of its detent locations.
Miter Detents, are ten slots that allow for fast and
accurate miter cuts at common miter angles.
Miter Scale and Pointer allows you to see the angle
setting before a cut is made. The pointer rotates with
the table and blade and points to the angle on the miter
scale.
Miter Lock Knob locks the miter saw table at any
desired miter angle.
Miter Detent Override Button locks out detent ac-
tion, allowing for micro-adjustments to any miter angle.
Table provides workpiece support, rotates for desired
miter cuts, and rotates the head assembly. The front
extended part of the table is called the miter arm.
Rubber Deflector is attached to the bottom of the
dust chute and deflects dust into the chute.
Chip Deflector prevents cut-off workpieces from
entering the upper guard.
Blade is the component that makes cuts in workpiec-
es. Use only 10" (254mm) diameter blades with 5/8"
(15.88mm) diameter arbor holes.
Lower Blade Guard/Lower Guard Lip helps protect
your hands from the spinning blade. It retracts as the
blade is lowered. Should the guard become jammed
on a workpiece, the lip can be used to raise the lower
guard.
Upper Guard covers upper part of the blade.
Publicidad
