Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 31
No-Hand Zone
No-Hand Zone
6˝
(152 mm)
The "No Hands Zone" for all slide and miter right cuts (Fig.
32).
Fig. 32
The "No Hands Zone" for all slide and miter left cuts (Fig. 33).
Fig. 33
6˝ (152 mm)
6˝ (152 mm)
With all bevel cuts the "No Hands Zone" extends vertically up
to the bottom of the upper guard when the head assembly is
in the lowest cut position (Fig. 34).
Use sliding fence outside No Hands Zone
Use sliding fence (Fig. 35, 12) and additional workpiece sup-
ports to properly support the workpiece and hold or clamp
it outside of the "No Hands Zone" (Fig. 31, Fig. 32, Fig. 33,
Fig. 34).
Preparing for Saw Operations
6˝
(152 mm)
6˝ (152 mm)
6˝ (152 mm)
-31-
Fig. 34
N o - H a n d
N o - H a n d
No-Hand
No-Hand
Tool
Blade
Workpiece can be held against table (Fig. 35, 22) and fence
(12) by hand only outside of the "No Hands Zone."
• Hold workpiece firmly against table and fence to
prevent movement.
• Keep hands in position until trigger has been re-
leased and blade has completely stopped.
• Never place hands on mechanism components.
• Keep feet firmly on the floor and maintain proper
balance.
• Follow the miter arm when mitering left or right.
Stand slightly to the side of the saw blade.
Fig. 35
42
12
Bevel
Angle
Upper
Guard
Table
Top
Z o n e
Z o n e
Zone
Zone
Lip
26
22
Workpiece
Publicidad
