Publicidad
Idiomas disponibles
Idiomas disponibles
To avoid possible injury, disconnect battery pack before performing any assembly, adjustments
or repairs.
Storing the Torx Wrench
There is a storage location on the saw to store the Torx wrench
(Fig. 7, 41). Insert the short leg of the Torx wrench through
the rubber grommet as shown. Place the long leg into the tool
rest.
NOTE: The Torx wrench (41) is needed to change the blade
and to attach the side extensions. If lost, use a Torx 30 wrench
or a key.
Fig. 7
41
Assembly
Attaching the Miter Lock Knob
1. Locate the miter lock knob (20) from among the loose
parts.
2. Look under the turntable's front arm, below the miter de-
tent override button (Fig. 8, 21), and locate the 10mm
hole.
Fig. 8
3. Insert the long shaft of the miter lock knob through this
hole until it stops.
4. Turn the knob clockwise (about 8 full revolutions) until it
is tight or "locked."
5. Loosen the knob 1/2 turn to unlock it. The table is now
free to be moved on the base.
-18-
21
Publicidad
