Publicidad
Idiomas disponibles
Idiomas disponibles
Miter and Bevel Settings for Standard Crown Molding Cuts
Assumptions: Molding is milled consistently. Corner is exactly 90°.
NOTE: Always place top edge
against fence
Inside Corner
Left end (Fig. 55, A)
Use the left end of the cut
Right end (Fig. 55, B)
Use the right end of the cut
Outside Corner
Left end (Fig. 55, C)
Use the left end of the cut
Right end (Fig. 55, D)
Use the right end of the cut
Fig. 55
Inside
corner
Saw Operations
(With Molding Flat on Table)
Molding
Spring Angle 38°
Miter (Table)
Setting
31.6° Right
31.6° Left
31.6° Left
31.6° Right
Outside
corner
Ceiling
52°
38°
38/52° crown
molding
38° spring angle
-47-
Spring Angle 45°
Bevel (Tilt)
Miter (Table)
Setting
Setting
33.9° Left
35.3° Right
33.9° Right
35.3° Left
33.9° Right
35.3° Left
33.9° Left
35.3° Right
Fence
Top of
molding
against
fence
Table
Ceiling
45°
45°
45/45° crown
molding
45° spring angle
Molding
Bevel (Tilt)
Setting
30° Left
30° Right
30° Right
30° Left
Publicidad
