Operating Instructions; Start-Up - Telstar BiOptima Manual De Usuario

4. OPERATING INSTRUCTIONS

4.1.

START-UP

Once the above points have been controlled, start up the MSC by pressing the On/Off button
(Annex A3, pos. 1). After entering the password correctly (by default the password is 0000)
or immediately if this function has been disabled, the fans will automatically start working.
Ensure that the aspiration area and air exhaust outlet are free (Annexes A1 & A2, pos. 7 &
8).
The electronic system of regulation by microprocessor via two thermoanemometer probe,
laminar down flow and exhaust airflow, needs a few seconds to stabilise during connection in
order to begin to work normally.
The cabinet can only be used by qualified staff who meets the correct work techniques in the
laboratory. If these techniques are not fulfilled, faulty working of the equipment may happen.
WARNING
The EN 12469 certification does not allow the deactivation of the password enquiry.
UM-BiOptima-EN-1907 15 / 39