Descargar Imprimir esta página

Chamberlain LiftMaster PROFESSIONAL SECURITY + 1210E FS2 Manual Del Propietário página 23

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION STEP 7
Install the Lights
• Press the release tabs on both sides of lens. Gently
rotate lens back and downward until the lens hinge
is in the fully open position. Do not remove the
lens.
• Install up to a 100 watt maximum light bulb in each
socket. The lights will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the lights will turn OFF.
• Reverse the procedure to close the lens.
• If the bulbs burn out prematurely due to vibration,
replace with a Garage Door Opener bulb.
NOTE: Use only standard light bulbs. The use of
short neck or speciality light bulbs may overheat the
endpanel or light socket.
INSTALLATION STEP 8
Attach the Emergency Release
Rope and Handle
• Thread one end of the rope through the hole in the
top of the red handle so "NOTICE" reads right side
up as shown. Secure with an overhand knot at
least 25 mm from the end of the rope to prevent
slipping.
• Thread the other end of the rope through the hole
in the release arm of the outer trolley.
• Adjust rope length so the handle is 1.8 m above
the floor. Secure with an overhand knot.
• Optional installation: As an added security option
a padlock may be installed on the trolley release
arm. To utilize this feature you must drill a hole
4.5 mm - 8 mm on the dimple which is located on
the trolley release arm. Install the padlock. When
using this feature the emergency release will not
work until the padlock is removed.
NOTE: If it is necessary to cut the rope, heat seal
the cut end with a match or lighter to prevent
unraveling.
WARNING
CAUTION
To prevent possible OVERHEATING of the endpanel or
light socket,
• DO NOT use short neck or specialty light bulbs.
• DO NOT use halogen bulbs. Use ONLY incandescent.
Release Tab
100 Watt (Max)
Standard Light Bulb
WARNING
To prevent possible SERIOUS INJURY or DEATH from a
falling garage door:
CAUTION
• If possible, use emergency release handle to disengage
trolley ONLY when garage door is CLOSED. Weak or
broken springs or unbalanced door could result in an
open door falling rapidly and/or unexpectedly.
• NEVER use emergency release handle unless garage
doorway is clear of persons and obstructions.
• NEVER use handle to pull door open or closed. If rope
knot becomes untied, you could fall.
Dimple for trolley lock
Trolley
23
100 Watt (Max)
Standard Light Bulb
Lens
Hinge
Overhand
Knot
Trolley
Release Arm
Rope
Emergency
Release Handle

Publicidad

loading

Este manual también es adecuado para:

Liftmaster professional security + 1220e fs2