cecotec HYDROBOOST 1400 EASYGO Manual De Instrucciones página 76

ENGLISH
- Do not use the product with hot water.
- Before setting the spray nozzle pressure (high to low or low to high), release the trigger.
- Never use the unit for more than 1 minute without spraying water.
5. CLEANING AND MAINTENANCE
- Use only cleaning products specific for pressure washers.
- The machine must be switched off and disconnected from the mains for cleaning or
maintenance.
- Do not store the pressure washer outdoors or where it can freeze, the pump could be
severely damaged.
Cleaning the nozzle
- A clogged or partially clogged nozzle can significantly reduce water output and cause
intermittent jetting. To clean the nozzle:
- Turn off and unplug the unit.
- Disconnect the water supply. Press the trigger 2 or 3 times to release the pressure trapped
in the hose.
- Remove the lance from the trigger gun.
- Turn the nozzle to concentrated mode to activate the internal blades.
- Use the nozzle-cleaning needle provided or any pointy, thin item to clean the nozzle, e.g.,
insert an unfolded paper clip into the nozzle hole. Move it inwards and outwards until all
dust and dirt is removed. Fig. 9
- Pour water through the nozzle hole into the nozzle to clean the dirt remains. To do this,
point a lighted garden hose at the nozzle for 30-60 seconds.
76
HIDROBOOST 1400 EASYGO