Using soap
Water and soap must be used in a 1:19 ratio: 5.4% soap, 94.6% water.
Warning
Use only soaps designed for pressure washers.
-
Test the soap in an inconspicuous place before using the product.
-
Loosen the cap of the soap bottle and fill it with water and soap.
-
Replace the cover.
-
Disassemble the lance from the trigger gun.
-
Attach the soap bottle to the trigger gun. Fig. 8
-
Apply soap in such a way to cover the whole surface to be cleaned. Apply it from bottom to
top to prevent soap from dripping down and staining the surface.
-
Leave the soap to act on the surface for several minutes. However, in particularly soiled
areas, use a brush to gently scrub. Do not allow soap to dry on the surface.
-
Remove the soap bottle from the trigger gun and replace it with the lance and spray nozzle
or accessory to be used.
-
Rinse the soap from the surface.
Note: rinse the soap bottle with clean water after every use.
Final rinse
Start the final rinse from bottom to top. Make sure that the surface is well rinsed and that all
dirt has been removed.
Turning off
-
Make sure there is no detergent in the system.
-
Turn off the motor. Turn off the water supply.
-
Once the product and the water supply have been turned off, press the trigger to
depressurise the device.
-
After each use, wipe the surface of the pressure washer with a clean, damp cloth.
Warning
-
Do not turn off the water supply until the motor has been switched off, as this could cause
serious damage to the pump and motor.
-
Do not remove the high-pressure hose from the machine while the system is being
pressurised. To depressurise the device, turn off the motor and water supply and press the
trigger 2 or 3 times.
Tips for extending the shelf life of the product
-
Do not use the product without water.
ENGLISH
HIDROBOOST 1400 EASYGO
75