Publicidad
Idiomas disponibles
Idiomas disponibles
6. TROUBLESHOOTING
Problem
Smoke comes out of the
device.
There is not enough
pressure.
The pressure washer does
not turn on.
Pressure fluctuates.
The motor stops suddenly. The extension cord is too long
Possible causes
Overheating, overloading, or
motor failure.
The water inlet filter is
clogged.
Air is entering from the hose
connections to the pump.
The nozzle or discharge valve
is worn or are not of the
correct size.
The unit is pressurised.
The plug is not properly
connected or the socket is
defective.
The extension cord is too long
or short.
The supply voltage is too low.
The thermal safety switch
has tripped.
The pump is sucking in air.
The nozzle is clogged.
The valves are dirty or worn.
Hydraulic seals are worn.
or short.
The thermal safety
switch has tripped due to
overheating.
ENGLISH
Possible solutions
Switch off the device
immediately and contact
the Technical Support
Service of Cecotec.
Clean the water inlet filter.
Check that the connections
and the locking ring are tight.
Contact the Technical Support
Service of Cecotec
Press the gun trigger.
Check the plug,
the socket, and fuses.
Remove the extension cord.
Make sure that the mains
voltage matches the voltage
stated on the rating label of
the appliance.
Switch off the device and
allow it to cool down.
Check that hoses and
connections are airtight.
Clean them with the nozzle-
cleaning needle.
Contact the Technical Support
Service of Cecotec.
Remove the extension cord.
Make sure that the mains
voltage matches the voltage
stated on the rating label of
the appliance.
HIDROBOOST 1400 EASYGO
77
Publicidad
