Picture Features; Digital Vnr; Colour System - JVC AV-32H35SUE Manual De Instrucciones

PICTURE FEATURES

Refer to "Using the TV's menu" (see
page 18) for details of displaying the menu.
PICTURE FEATURES

DIGITAL VNR

COLOUR SYSTEM

4:3 AUTO ASPECT
PICTIRE TILT
BACK
TV
OK
D0015-EN
DIGITAL VNR
The DIGITAL VNR function cuts down the
amount of noise in the original picture.
You can choose from the three DIGITAL
VNR function settings of AUTO, MIN and
MAX.
The TV and external input may be given
different DIGITAL VNR settings.
AUTO:
The TV will automatically adjust the level of
the DIGITAL VNR effect to match the
amount of noise in the picture, giving you the
best possible picture.
• If you set the DIGITAL VNR effect too
high it can make the picture less sharp. It
is recommended to use the AUTO setting
if you can.
MIN:
The level of the DIGITAL VNR effect is set
to the minimum. If you set the DIGITAL
VNR function to AUTO but feel that the
sharpness of the original picture has not been
reproduced fully, change the setting from
AUTO to MIN.
• The MIN setting is not suitable for low-
quality pictures which contain a lot of
noise.
MAX:
The level of the DIGITAL VNR effect is set
to the maximum. If you set the DIGITAL
VNR function to AUTO but still notice some
noise, change the setting from AUTO to
MAX.
• The MAX setting is not suitable for high-
quality pictures which contain very little
noise.
20
AUTO
OFF:
The DIGITAL VNR function is turned off.
COLOUR SYSTEM
The colour system is chosen automatically.
However, if the picture is not clear or no
colour appears, choose the colour system
manually.
COLOUR SYSTEM
PAL
BACK
TV OK
D1016EN
1 Choose COLOUR SYSTEM then
press the a a a a button
2 Press the 5 5 buttons to chose the
5 5
appropriate colour system.
Then press the a
PAL:
PAL system
SECAM:
SECAM system
NTSC 3.58:
NTSC 3.58 MHz system
NTSC 4.43:
NTSC 4.43 MHz system
AUTO:
This function detects a colour system from
the input signal. Only when you are viewing
a picture from Programme number PR 0
(AV), or EXT terminal, you can choose using
the AUTO function.
• The AUTO function may not function
properly if you have poor signal quality.
If the picture is abnormal in the AUTO
function, choose another colour system
manually.
• When in the Programme numbers PR 0
(AV) to PR 99, you cannot choose NTSC
3.58 or NTSC 4.43.
a button a a