cecotec HYDROBOOST 3200 INDUCTION PROCLEAN Manual De Instrucciones página 36

ENGLISH
Warning
- Do not turn off the water supply until the motor has been switched off, as this could cause
serious damage to the pump and motor.
- Do not remove the high pressure hose from the machine while the system is being
pressurised. To depressurise the device, turn off the motor and water supply and press the
trigger 2 or 3 times.
Tips for extending the product shelf life
- Do not use the product without water.
- Do not use the product with hot water.
- Never use the unit for more than 1 minute without spraying water.
5. CLEANING AND MAINTENANCE
- Use only cleaning products specific for pressure washers.
- The machine must be switched off and disconnected from the mains for cleaning or
maintenance.
- Do not store the pressure washer outdoors or where it can freeze, the pump could be
severely damaged.
- The water inlet anti-impurities filter must be regularly checked to prevent blockages in the
water supply to the pump. Fig 8
Nozzle cleaning
- A clogged or partially clogged nozzle can significantly reduce water output and cause
intermittent jetting. To clean the nozzle:
- Turn off and unplug the unit.
- Disconnect the water supply. Press the trigger 2 or 3 times to release the pressure trapped
in the hose.
- Disassemble the wand.
- Turn the nozzle to concentrate mode, this will activate the internal blades.
- Use the cleaning clip provided, or any pointed item to clean the nozzle, e.g. insert an
unfolded paper clip into the nozzle hole. Move it inwards and outwards until all dust and
dirt is removed. Fig. 9
- Pour water through the nozzle hole into the nozzle in order to clean the dirt remains. To do
this, point a lighted garden hose at the nozzle for 30-60 seconds.
H Y D R O B O O S T 3200 INDUCTION PROCLEAN
70
6. TROUBLESHOOTING
Problem Cause
Smoke comes out of the Overheating, overloading or
appliance. motor failure.
There is not enough pressure. The inlet water filter is
clogged.
Air is entering from the hose
connections to the pump.
The nozzle or discharge valve
is worn or not the correct
size.
The pressure washer does The unit is pressurised.
not turn on. The plug is not properly
connected or the socket is
defective.
The extension cord is too long
or short.
The supply voltage is too low.
The thermal safety switch
has tripped.
Pressure fluctuates. The pump is sucking in air.
The nozzle is clogged.
The valves are dirty or worn.
Hydraulic seals are worn.
The motor stops suddenly. The extension cord is too long
or short.
The thermal safety
switch has tripped due to
overheating.
H Y D R O B O O S T 3200 INDUCTION PROCLEAN
ENGLISH
Solution
Turn off the device
immediately and contact the
Technical Support Service of
Cecotec.
Service of Cecotec.
Clean the inlet water filter.
Check that the connections
and the locking ring are tight.
Contact the Technical Support
Service of Cecotec.
Press the gun trigger.
Check the plug, the mains and
the fuses.
Remove the extension cord.
Make sure that the mains
voltage matches the voltage
stated on the rating label of
the appliance.
Switch off the device and
allow it to cool down.
Check that hoses and
connections are tight.
Clean them with the cleaning
clip.
Contact the Technical Support
Service of Cecotec.
Remove the extension cord.
Make sure that the mains
voltage matches the voltage
stated on the rating label of
the appliance.
71