Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
en
5.4
Integration of the sensor in IO-Link mode
46
O P E R A T I N G I N S T R U C T I O N S | WTM4S
PNP
Push-pull
NPN
PNP
Push-pull
NPN
Table 6: Push-pull, PNP, NPN
PNP
Push-pull
NPN
PNP
Push-pull
NPN
To operate the product in IO-Link mode, it must be connected to a suitable IO-Link
Master. This is used for further integration into the control system.
NOTE
The cable length between the IO-Link Master and IO-Link device: maximum 20 m.
Details on integration can be found in the detailed IO-Link description:
mation: Photoelectric sensors, SICK Smart Sensors /
+ (L+)
Q ≤ 100 mA
Push-pull
‒ (M)
+ (L+)
Q ≤ 100 mA
Push-pull
‒ (M)
MultiMode 4:
+ (L+)
Q ≤ 100 mA
Push-pull
‒ (M)
+ (L+)
Q ≤ 100 mA
Push-pull
‒ (M)
IO-Link.
+ (L+)
PNP
Q ≤ 100 mA
NPN
‒ (M)
+ (L+)
PNP
Q ≤ 100 mA
NPN
‒ (M)
Q
/Q
L1
L2
+ (L+)
PNP
Q ≤ 100 mA
NPN
‒ (M)
+ (L+)
PNP
Q ≤ 100 mA
NPN
‒ (M)
Technical Infor‐
8028212/2023/10/20 | SICK
Subject to change without notice
Publicidad
