Publicidad
Idiomas disponibles
Idiomas disponibles
• Do not turn on the power until all work has been completed.
•
When moving or relocating the air conditioner, consult experienced service
technicians for disconnection and reinstallation of the unit.
How to install the appliance to its support, please read the information for
•
details in "indoor unit installation" and "outdoor unit installation" sections .
•
Excessive Weight Hazard - Use two or more people when moving and installing
the unit. Failure to do so can result in back or other type of injury.
WARNINGS FOR CLEANING AND MAINTENANCE
• Turn off the device and disconnect the power before cleaning. Failure to do so
can cause electrical shock.
• Do not clean the air conditioner with excessive amounts of water.
• Do not clean the air conditioner with combustible cleaning agents. Combustible
cleaning agents can cause fire or deformation.
NOTE ABOUT FUSE SPECIFICATIONS
The air conditioner's circuit board (PCB) may be designed with a fuse to provide
•
overcurrent protection. This fuse must be replaces with identical component.
•
The specifications of the fuse, if equipped, are printed on the circuit board,
examples of such are T5A/250VAC and T10A/250VAC.
NOTE ABOUT FLUORINATED GASSES (NOT APPLICABLE TO THE
UNIT USING R32 REFRIGERANT)
This air-conditioning unit contains fluorinated green house gasses. For specific
•
information on the type of gas and the amount, please refer to the relevant label
on the unit itself or the "Owner's Manual - Product Fiche " in the packaging of the
outdoor unit. (Product Fiche for European Union products only).
Installation, service, maintenance and repair of this unit must be performed by a
•
certified technician.
Product uninstallation and recycling must be performed by a certified technician.
•
When the unit is checked for leaks, proper record-keeping of all checks is strongly
•
recommended.
FOR FLAMMABLE REFRIGERANT
•
When flammable refrigerant are emploved appliance shall be stored in a
well-ventilated area where the room size corresponds to the room area as
specifiec for operation. For R32 frigerant models,the minimum room size please
see the following form:
6
V.1
Publicidad
