cecotec POWER ESPRESSO 20 STEEL PRO LATTE Manual De Instrucciones página 22

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Cup heating zone
2. Pressure indicator
3. Control panel
4. Filter holder bracket
5. Metal grille
6. Drip tray
7. Inner drip tray
8. 1-cup filter
9. 2-cup filter
10. Filter holder
11. Water tank
12. Milk tank cover
13. Milk outlet knob
14. Milk tank locking switch
15. Milk tank pipe
16. Milk tank connector
17. Milk spout
18. Milk tank
19. Milk tank base
20. Pressing powder spoon
Control panel
Figure 2
A. Power button
B. Espresso button
C. Cappuccino button
D. Latte button
E. Pressure gauge
NOTE:
the graphics in this manual are schematic representations and may not exactly match the
device.
42 POWER ESPRESSO 20 STEEL PRO LATTE
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
- Wash the water tank with its cover, the milk tank with its cover, the pressing powder spoon
and filter as well as the filter holder with lukewarm water and a little neutral dishwashing
detergent. After that, rinse with clean water and dry.
- Also, clean the housing of the espresso machine and the drip tray with its grille with a soft,
damp cloth and dry all parts.
Box content
- Power Espresso 20 Steel Pro Latte Espresso Machine
- Filter holder
- 1-cup filter
- 2-cup filter
- Pressing powder spoon
- Milk tank
- Instruction manual
3. OPERATION
1. Fill the water and the milk tank with cold water up to the MAX mark on the tank.
2. Connect the plug to a socket that has a suitable voltage.
3. Press the power button. Next, the indicator light will turn on and the espresso machine
will automatically start to preheat. Once the preheating process is completed, all buttons
will light up steadily. The preheating process takes about 2 minutes.
4. Place a cup under the coffee spout, turn the milk spout and press and hold the Latte
button for three seconds. Let the hot water run out for about 8 seconds and press the
Latte button again to stop the water flow. This process allows the water to pass through
to the pump the first time it is used, and it also cleans the pipes.
ATTENTION: the first time you use the espresso machine it may make a loud noise or vibrate.
This is normal for a 20-bar pressure pump. When you use it again, it will make less noise.
ENGLISH
POWER ESPRESSO 20 STEEL PRO LATTE 43