cecotec DRUMFIT INDOOR 10000 MAGNETIC CONNECTED Manual De Instrucciones página 48

ENGLISH
Box content
- Drumfit Indoor 10000 Magnetic Connected stationary bicycle
- Assembly tools
- Instruction manual
3. PRODUCT ASSEMBLY
Stabilisers installation
Use the Allen key (S7) to remove the pre-installed stabiliser screws, align the main frame with
the stabiliser holes and tighten the screws with the Allen key (S7). Fig. 3
Saddle installation
Align the holes as shown in the figure below and use the adjustment knob (S6) and the flat
washer (S3) to secure the saddle post.
Warning: The saddle inclination can be adjusted. Fig. 4
Handlebar and console installation
Using the Allen key (S7), secure the handlebar with the screws (S1) (S2), the spring washers
(S5) and the flat washers on the handlebar stem. Attach the handlebar trim and console, then
use the two adjustment knobs on the main frame to secure the handlebar stem and saddle
post. Fig. 5
Pedals installation
Use the spanner (S8) to install the pedals on the crank and tighten them firmly.
Note
- The pedals are distinguished between left (L) and right (R) with the corresponding letters.
- Do not install them in the wrong position. Fig. 6
4. OPERATION
Resistance adjustment
To adjust the resistance level, simply use the adjustment knob on the main frame. To increase
the resistance, turn the knob clockwise (+); to decrease the resistance, turn it counterclockwise
(-). Press the knob to stop the stationary bike from moving. Fig. 7
Adjusting the saddle height
To adjust the saddle height, simply turn the adjustment knob on the back of the main frame
counterclockwise twice, pull it outwards and then freely adjust to the desired height. Once
adjustment is complete, tighten the knob by turning clockwise. Fig. 8
48 DRUMFIT INDOOR 10000 MAGNETIC CONNECTED