Self-Diagnosis Display/Warning Indicators - Sony Handycam DCR-PJ5 Guía De Operaciónes

Ocultar thumbs Ver también para Handycam DCR-PJ5:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

unnecessary images (p. 20).
Total number of movie scenes or photos has
exceeded the recordable capacity of your
camcorder. Delete unnecessary images (p. 20).
The recording stops.
The temperature of your camcorder is
extremely high/low. Turn off your camcorder
and leave it for a while in a cool/warm place.
"PMB" cannot be installed.
Check the computer environment or
installation procedure required to install
"PMB" (p. 33).
"PMB" does not work correctly.
Quit "PMB" and restart your computer.
The camcorder is not recognized by the
computer.
Disconnect devices from the USB jack of the
computer other than the keyboard, mouse,
and your camcorder.
Disconnect the USB cable from the computer
and your camcorder, and restart the computer,
then connect the computer and your
camcorder again in an orderly manner.
Self-diagnosis display/Warning
indicators
If indicators appear on the LCD screen,
check the following.
If the problem persists even after you
have tried to fix a couple of times, contact
your Sony dealer or local authorized Sony
service facility. In this case, when you
contact them, give them all the numbers of
the error code beginning with C or E.
C:04:
The battery pack is not an "InfoLITHIUM"
battery pack V series. Use an "InfoLITHIUM"
battery pack (V series).
Connect the DC plug of the AC Adaptor to
your camcorder securely (p. 13).
C:06:
The battery pack temperature is high. Change
the battery pack or place it in a cool place.
C:13: / C:32:
Remove the power source. Reconnect it and
operate your camcorder again.
E::
Follow the steps from  to  on page 46.
The indicator flashes when the internal hard
disk of your camcorder becomes full. Delete
unnecessary images (p. 20), or format the
internal hard disk (p. 54) after storing the
images on other media.
An error may have occurred with the internal
hard disk of your camcorder.
Battery power is low.
The battery pack temperature is high. Change
the battery pack or place it in a cool place.
The temperature of your camcorder is getting
high. Turn off your camcorder and leave it in
a cool place.
The temperature of your camcorder is low.
Make the camcorder warm.
No memory card is inserted (p. 14).
The indicator flashes when the memory card
US


Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Handycam dcr-sr21Handycam dcr-sx21

Tabla de contenido