Behncke PWT 510 Instrucciones De Operación página 57

2.5.5 Leaks between the connections and the frame plates
URSACHE
The fluid is leaking from the connection and front
plate.
2.6 Risks from structural changes or faulty replacement parts
Structural changes may affect operational safety. As a result, the heat exchanger may only be converted
or modified by agreement with the manufacturer. No components, especially safety devices, may be
removed.
Only replacement parts and accessories from BEHNCKE may be used.
Any accessories must not endanger the safety of the system.
2.7 Safety measures at the installation site
The heat exchanger must be stably mounted on a level and solid surface or on a mounting plate, and is not
suitable for use in constant sunlight.
Only run the heat exchanger if all the safety devices of the peripheral equipment are fully functional.
The heat exchanger or surroundings may be damaged if the guidelines are not followed.
There must be a sufficiently large safety floor drain in the installation room to avoid water damage if there
are any leaks.
The installation space must not be colder than 5°C during operation, maintenance, start-up, cleaning or
repair.
CAUTION!
Check the heat exchanger at least once per week for watertightness, visible
external damage and functionality.
Heat exchanger PWT 510 / PWT 910 / Safety
LÖSUNG
If there is a flange connection with coating rubber,
check its integrity and check that it is positioned
correctly.
15