JVC HR-S8007UM Manual De Instrucciones página 83

EDITING
Edit To Or
From Another
VCR
Connection
Ex. When using this VCR as the playback VCR
This VCR (for playback)
To S VIDEO
OUT
S-video cable
(supplied)
To S-video
Input
Another VCR (for recording)
You can use your VCR as the playback or recording VCR.
● Refer also to the other VCR's instruction manual for
connection and its operations.
1
Make connections
Connect an audio/video cable between the
playback VCR's audio/video output connectors
and the recording VCR's audio/video input
connectors.
● If using another VCR with an S-VIDEO input or
output connector, it is recommended to use the
S-VIDEO connection to minimize picture
degradation while editing.
● When using this VCR as the recording VCR,
connect this VCR's audio/video input
connectors to the audio/video output
connectors on the other VCR.
Downloaded from: https://www.usersmanualguide.com/
PAUSE/
AV ANT. IN
IN OUT
COMPU
-LINK R
AUDIO
IN OUT
S
L
V
RF OUT
I
VIDEO
D
E CH3 CH4
O
To AUDIO/
VIDEO
OUT
Audio/video
cable (supplied)
To Audio/
video Input
2
Load cassettes
Insert the playback cassette into the playback
VCR and the cassette to be recorded on into the
recording VCR.
3
Select input mode on recording VCR
Select the correct external input on the other
VCR.
● On this VCR (when using this VCR as the
recording VCR);
Select "L-1" — when connecting the other VCR
to the audio/video input
connectors on the rear panel.
Select "F-1" — when connecting the other VCR
to the audio/video input
connectors on the front panel.
On the front panel:
Press CH5∞.
On the Remote:
Press the Number key "0 (AUX)" or PR +/–.
● If you use your VCR as the recorder, you
need to set "FRONT AUX INPUT" or "REAR
AUX INPUT" to appropriate mode (
30, 34)
4
Select edit mode
Set the edit mode to "ON" for the VCRs if such a
mode is equipped.
● On this VCR, set "PICTURE CONTROL" to
"EDIT" by following the procedure described
on pages 31.
5
Start playback
Press PLAY ( 3 ) on the playback VCR.
NOTE:
If the playback VCR is equipped with a superimpose
disable feature then set it to "OFF" before starting
playback ( pg. 31).
6
Start recording
Press REC ( ¶ ) on the recording VCR.
NOTE:
Be sure to select "AUTO" for "PICTURE CONTROL" (or
"NORM" when "B.E.S.T." is set to "OFF") after you finish
dubbing the tapes ( pg. 31).
35
EN
pg.