Publicidad
Idiomas disponibles
Idiomas disponibles
40
EN
DBS Receiver
Brand Setting
2
–1 3
CABLE
/SAT
1
DBS RECEIVER BRAND NAME
JVC (DISH Network)
ECHOSTAR (DISH Network)
PRIMESTAR
RCA (DSS)
SKY
SONY (DSS)
ATTENTION
The remote control can operate not only the video recorder but
also some of your TV, cable box and DBS receiver.
● To operate your video recorder, first press the VCR button to
set the remote control to the Video mode.
● To operate your TV, first press the TV button to set the
remote control to the TV mode. (
● To operate your cable box or DBS receiver, first press the
CABLE/SAT button to set the remote control to the cable box
or DBS receiver mode. (
Downloaded from:
https://www.usersmanualguide.com/
1
2
3
2
4
5
6
8
9
7
4
0
BRAND CODE
pg. 38)
pg. 39, 40)
MULTI-BRAND REMOTE CONTROL (cont.)
This Remote can control some functions of the DBS
(Direct Broadcast Satellite) receivers listed below.
1
2
2
–2
Number
3
2
–3
ENTER
NOTES:
● Depending on the type of DBS receiver, some or all functions
cannot be operated using this Remote.
● It's not possible to operate a DBS receiver not equipped with
TV PR +/–
a remote sensor.
● Though ECHOSTAR has a number of different remote codes,
this remote control is applicable only to one of those codes
preset at the factory.
● It's not possible to set the Remote for both your DBS receiver
and a cable box at the same time. You can only set the
Remote to operate one of these units at a time.
● You have to subscribe to a DBS service to receive DBS
channels.
51
(Ex.) To set the Remote to JVC 51:
51
50
40
52
41
Turn on the DBS receiver
Turn on the DBS receiver using the Power button
on the DBS receiver or its Remote.
Enter DBS receiver brand code
Follow the example shown below.
1 Press and hold CABLE/SAT.
2 Press the Number keys to enter your cable
box's brand code by referring to the table
below.
3 Press OK, and release CABLE/SAT.
The cable box should turn off. If it does, try
other operations below (
● Once you have set the Remote to operate the
DBS receiver, you do not have to set it until you
replace the batteries from the Remote.
Operate DBS receiver
First, press CABLE/SAT to set the Remote to Cable
Box mode, then press one of the following
buttons:
, TV PR +/–, and Number keys.
● For some brands, you must press ENTER after
having pressed the Number keys to enter a
channel number.
● To change the DBS receiver's channels, press
TV PR +/– or the Number keys.
CABLE
/SAT
5
1
Hold
Press in succession
down
step 3).
Release
Publicidad
