Working With The Machine - Festool ROTEX RO 90 DX FEQ Manual De Instrucciones

Slat sanding pad LSS-STF-RO90 - Fig. [8]
If the StickFix coating of the slat sanding pad is
worn, the complete table can be replaced. Open the
screws to do this [8-1].
Attaching sanding accessories
The suitable StickFix sandpaper and StickFix sand-
ing cloth can be attached quickly and simply to the
StickFix sanding pad.

Press the self-adhesive sanding accessory onto
the sanding pad [1-7].
Use only abrasives with an undamaged
Stickfix hook-and-loop coating. Before use,
check that the coating has not been dam-
aged by improper use (such as overheating).
Attaching polishing accessories
To prevent damage, PoliStick accessories (polish-
ing sponges, polishing felt, sheepskin) must only be
used on the special polishing pad.

Press the self-adhesive polishing accessory
onto the sanding pad [1-9].
WARNING
Risk of injury

Always secure the workpiece in such a manner
that it cannot move while being machined.
Dust hazard

Dust can be hazardous to health. Always work
with a dust extractor.

Always read applicable national regulations be-
fore extracting hazardous dust.
At the extractor connector [1-5], a Festool mobile
dust extractor with an extraction hose diameter of
27 mm can be connected.
The edge protector [1-1] reduces contact of the
sanding pad circumference with a surface (e.g.
when sanding along a wall or a window), thus pre-
venting back-kick of the machine, or machine dam-
age.

Working with the machine

Observe the following instructions:
– Do not overload the machine by pressing with ex-
cessive force! The best sanding results are
achieved with moderate application pressure.
The sanding capacity and quality are mainly de-
pendent on the selection of the correct abrasive.
Dust extraction
WARNING
Edge protector - Fig. [9]
13