Publicidad
Idiomas disponibles
Idiomas disponibles
7. TROUBLE SHOOTING CHECK LIST
Before asking for a technical assistance service, please follow this list to try to solve most common problems:
PROBLEM
The machine does not work
Working temperature not sufficient
Egg-turner device not Working properly
Forced ventilation not sufficient
Interior lighting not working
Thermometer / hygrometer alcohl
column interrupted
Not possible to regulate the fan speed
Incorrect humidity reading
Automatic humidity system does not work correctly
Low humidity value
(with semiautomatic humidification system)
Water loss
It is not recommended to attempt any repairs not listed above, contact the technical assistance point
8
Correct working of the fan should be checked visually, faulty operation of the fan could compromise incubation results.
CAUSE
Lack of power
Plug disconnected
Master switch "0/I" on position "0"
Safety fuse burnt
Any of the above points
Heating element not correctly working
Thermostat not calibrated
Thermostat faulty or not working
Door open
Egg-turner motor broken
Fan not working
Switch on "0" position
Lamp burnt
Accidental drops or jarring of the
thermometer/hygrometer
The fan speed regolator does not work
Hygrostat not calibrated
Hygrostat bador not working
Automatic humidity does not work properly:
broken humidifier
plug not inserted
hygrostat out of calibration
faulty humidity probe
no water into humidifier check
Empty external tank
Natural surface humidification system
does not work correctly
Water float damaged
Float does not work correctly
Float blocked because limestone
tel. 031 / 97 66 72 isdn – fax.031/ 89 91 63
www.fiem.it / www.fiem.eu – e-mails: info@fiem.it - incubators@fiem.it – fiem@fiem.it
8
SOLUTION
Check the plug
Put the plug into the socket
Positionate the switch on "I"
Replace the fuse
Contact the assistance service
Contact the manufacturer
See instruction for calibration
Contact the manufacturer
Close the door
Contact the manufacturer
Contact the manufacturer
Place the switch on "I" position
Replace the lamp as shown
in the instructions
Try to put the thermometer at low
temperature (in a freezer) for few
minutes, and then allow to return to
room temperature.
Otherwise replace the thermometer
See instruction ref. lcd control unit
See instruction for calibration -
ref. lcd control unit
Contact the builder
Contact the builder
Insert the plug;
see the paragraph
lcd unit control hygrostat set-up;
Contact the builder
the correct water system
lacing or the possible lack of water;
Fill water
Check the fall down water from external water
to the internal basin
Check the water level setted from the float
Check the float
Clean the float putting a solution of water
70% + white vinegar 30% inside the
water basin for 2/3 hours.
25
Publicidad
