Publicidad
Idiomas disponibles
Idiomas disponibles
BUOYANCY MECHANISM – Assembly on the Hull
II-1-ASSEMBLING THE BUOYANCY MECHANISM ON THE HULL
1
To facilitate the positioning of the buoyancy mechanism, apply liquid soap (A) to the hull
rails
2
Place the bolt rope (a) of the buoyancy mechanism in the hull rail (b) located in the bow of
the hull. Pull on the buoyancy mechanism until the mini-bolt rope faces the rail.
3
- Proceed in the same way for the other side of the buoyancy mechanism.
- Move the tip of the buoyancy mechanism forwards to fold the outer flap down under the
tip of the hull.
- Pull the 2 tabs of the buoyancy mechanism again as far as possible towards the aft end of
the boat, and try to centre the tip with the bow of the hull.
- Slightly inflate the tip of the buoyancy mechanism to check that it has been well centred
and that it matches the hull perfectly. Begin the operation again if the buoyancy
mechanism is not correctly positioned.
10 / 47
Publicidad
