Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the unit
6.2. Fastening the unit
The fixing points are designed for the use of threaded rods or M12 screws. If using a threaded rod, its length above
the ground must be 25 to 35 mm.
Other similar anchoring systems can be used.
The separation of the fastening system selected must be adjusted to the measurements shown below in a detail of
the lower part of the charger.
You must follow the following stipulations when choosing the place where the unit is to be bolted in:
•
Minimum distance from the center of the bore to the outer edge of the concrete pad: 75 mm.
•
The distance from the center of the bore to the inner edges must be 39 mm.
300000772 - Monterings- och bruksanvisning
726
258
Ingeteam
EN
ES
FR
IT
SV
134
39
Publicidad
