Ingeteam RAPID 60 Manual De Instalacion Y Uso página 43

Connection of accessories
7.3.2. Electrical connection
Switch power supply:
1. The Ethernet switch kit includes two blue cables which must be connected to the switch connector in the
+ and – positions, in accordance with the printing on the cables.
2. Next, the cables must be routed through the ducts to the –XD2 distribution terminal block. Connect the
other end of the cables in accordance with the printing on the cables to points 5+:1 and 1-:4.
-XD2
-XD1
Terminal communications:
1. Disconnect one of the Ethernet cables from the connection terminal shown in the figure below.
300000772 - Monterings- och bruksanvisning
Ingeteam
EN
ES
FR
IT
SV
43