INFOSEC UPS SYSTEM E4 Pro One Serie Manual De Usuario página 43

3-5. LCD screen settings
Parameter 1 Parameter 2
01 : Output voltage
⚫
Interface
02: Enable/disable frequency converter
⚫
Interface
03: Output frequency setting
⚫
Interface
04: Activates or deactivates ECO mode
⚫
Interface
INFOSEC UPS SYSTEM – 15, Rue du Moulin – 44880 Sautron – France – www.infosec-ups.com Hot Line Tel : +33
(0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 11 23 AA 59 204 16
There are two parameters for setting the UPS
Parameter 1: Used to select programs or setting options. See
the following table.
Parameter 2: concerns the setting options for each program
Configuration
Parameter 2: Output voltage
The following output voltage can be selected in parameter 3 :
200: Gives an output voltage of 200 Vac
208: Outputs 208 Vac
220: Provides 220 Vac output voltage
230: Outputs 230 Vac (default)
240: Provides 240 Vac output voltage
Configuration
Parameter 2: Enable or disable converter mode. You can choose
from the following two options:
CF ENA: enable converter mode
CF DIS: disable converter mode (default)
Configuration
Parameter 2: Output frequency setting.
You can set the initial frequency on battery mode:
BAT 50: indicates that the output frequency is 50 Hz
BAT 60: indicates that the output frequency is 60 Hz
If converter mode is enabled, you can select the following output
frequency:
CF 50: indicates that the output frequency is 50 Hz
CF 60: indicates 60 Hz output frequency
Configuration
Parameter 2: Activates or deactivates the ECO function. You can
choose between the following two options:
DIS: deactivates ECO function (default)
ENA: activates ECO function
43