Warning Information - Truma Mover S Instrucciones De Uso

Route wire connected to pin 3 (black) to control unit (shorten if
necessary), crimp on a ring and screw to negative battery
terminal as shown in connecting diagram.
The connection to the control unit must be made in the
order – nut, battery negative terminal ring, nut, cable
pin 3 ring, nut.
Re-check whether all cables are correctly connected, attached
using the provided clips and cannot chafe.
Safety socket connection
with LED brake lights
This connection must always be used if all brake lights are
of the LED variety! With two conventional brake lights
and a third brake light with LED technology, the connection
is made as described in „Safety socket connection with
conventional brake lights".
7-pin safety socket:
Connect pin 3 of the caravan plug to the negative battery
terminal.
Connect pin 3 of the safety socket to the controller (with one
wire of the 2-wire cable).
13-pin safety socket:
Connect pin 11 of the caravan plug to the negative battery
terminal.
Connect pin 11 of the safety socket to the controller (with
one wire of the 2-wire cable).
If it is not possible to make a connection using pin 11 (pin
missing, for example), use pin 3 as an alternative.
It must be ensured that ground connections pin 11
and pin 3 are not interconnected in an electrically
conductive manner at the trailer side!
Connecting diagram with LED brake lights
Swivel-in
motors Safety
contact
– + – +
1
6 2
Safety
7
socket
5 3
4
7-pin
1
Caravan
6 2
7
plug
3
5
4
Drive Drive
motor Battery motor
– +
4 3 2 1
8
7 9
1
6 10
4 2
-
+
11
5 3
13 12
13-pin
8
7 9
1
6 10
4 2
11
5 3
13 12
Commissioning the Mover
1. Ensure the battery used to operate the Mover is fully
charged.
2. Park the caravan outside on an open, level surface and apply
the handbrake. Ensure that the rollers are disengaged from the
road tyres and the corner steadies are raised.
3. Connect battery terminals to battery, check that all cables
are secure and not hot or indicating signs of short circuits, etc.
4. Plug the 13-pin plug into the safety socket.
If there is a fault in both caravan brake lights, the power
circuit of the safety socket is not closed. In this case the
Mover cannot be operated.
5. Move slide switch on remote hand set to the „On" I posi-
tion. This switches the remote hand set on – green LED flashes
for 5 seconds in combination with the acoustic alarm until the
control unit is ready for operation. If LED does not illuminate,
check polarity and condition of batteries in remote hand set.
The remote hand set switches itself off after about 2 minutes if
no buttons are pressed.
6. Check whether both drive motors are stationary. Press the
„forwards" button with the remote hand set switched on –
both drive motors must now move in the forward direction.
7. Swivel the drive rollers against the tyres using the remote
hand set.
8. Please ensure that there are no obstructions beneath the
caravan, then release the handbrake. Now check all functionality
as per the operating instructions.
9. Apply caravan brake. Swivel out the drive rollers and move
slide switch on remote hand set to the „Off"
switch the remote hand set and the Mover off. Re-check
distance between drive rollers and tyres. Adjust if necessary.
The distance between the swivelled-out drive rollers and
the tyres is 20 mm.

Warning information

The yellow sticker with the warning information, which is en-
closed with the appliance, must be affixed by the installer or
vehicle owner to a place in the vehicle where it is clearly visible
to all users (e.g. on the wardrobe door)! Ask Truma to send you
a sticker, if necessary.
Technical data Mover SE / TE
Operational voltage:
Current consumption:
Stand by consumption:
Remote hand set
frequency:
Speed:
Weight:
Area of operation
Mover SE:
Area of operation
Mover TE:
Right to effect technical modifications reserved!
£
position to
12 V DC
average approx. 20 A
maximum 120 A
< 15 mA
Class 1, 868 MHz
approx. 16 cm per second
(depending on weight and incline)
approx. 33 kg
Single axle caravans with a
total weight up to 1800 kg
Dual axle caravans with a
total weight up to 2250 kg
21