Publicidad
Idiomas disponibles
Idiomas disponibles
ACCESSORY ADAPTOR (FIG 3)
A universal accessory adaptor GAMT403 (not included) allows
the tool to use with other brands' accessories. (Fein®, Bosch®,
Dremel®, and Rockwell®). See FIG 3 for how to use that adaptor.
NOTE:
Fein is a registered trademark of C. &e Fein GmbH. Bosch is
a registered trademark of Robert Bosch GmbH. Dremel is a registered
trademark of Credo Technology Corp. Rockwell is a registered trademark of
Positec Group Limited.
OPERATION
WARNING:
personal injuries, read and follow all important safety
warning and instructions before using this tool.
WARNING:
before making any adjustments or setting up prior to cutting. Failure to disconnect or
unplug the tool may cause accidental starting, resulting in serious personal injury.
NOTE:
Always Check that the power supply
corresponds to the voltage on the ratings plate.
STARTING AND STOPPING THE
OSCILLATING TOOL (FIG 4)
To Start the Oscillating Tool, slide the ON/OFF switch forward to
ON position.
To Stop the Oscillating tool, slide the ON/OFF switch backward to
OFF position.
APPLICATIONS
NOTE:
Recommended oscillating tool accessories for this tool are the GENESIS™
oscillating tool accessories. Please refer to "Genesis Oscillating Tool Accessory
Reference Guide" Sheet enclosed for details.
This multi-purpose oscillating tool is intended for cutting and sanding wood, plastic, plaster and non-ferrous metals.
It is especially suitable for cutting in tight spaces and for flush cutting
CUTTING (FIG 5,6,7)
use a flush cutting saw blade (or "e-cut blade") for making precise
cuts in tight areas, close to edges, plunge or flush to a surface.
It is important not to force the tool during the flush cutting. If you
are experiencing a strong vibration in your hand during the cut, it
indicates too much pressure on the tool. Back off on the pressure
and let the speed of tool do the work. See FiG 5, 6 for typical uses
for flush cutting saw blade.
NOTE:
It is suggested that you have a piece of
scrap material supporting the blade when making a
flush cut. If you need to rest the blade on a delicate
surface, you need to use cardboard or masking tape
to protect the surface.
use the segmented saw blade (not included) for making continuous
precise cuts in wood, plaster or drywall material. Applications
include cutting openings for electrical boxes, repairing flooring,
cutting flooring for venting, and more. See FIG 7 for how to use of
the segmented saw blade.
Multi-Purpose Oscillating Tool
Operator's Manual
To reduce the risk of serious
Always be sure the tool is disconnected from the power source
ON
.
Following are a few typical uses.
FIG 5
GMT15P
ACCESSORY
ADAPTOR
FIG 3
OFF
FIG 4
FIG 6
Publicidad
