Descargar Imprimir esta página

Genesis GMT15P Manual Del Operario página 9

Herramienta oscilante multiuso

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY AND ADJUSTMENTS
WARNING:
adjusting, adding accessories, or checking a function on the tool.
To Install the Accessories (FIG 2)
1. Loosen the cap screw (a) using Allen wrench provided.
2. Slide the open-end of the accessory into the gap between the blade washer (d) and the shaft flange (b).
Place the accessory over the shaft flange (b). The shaft flange of this tool comes with a 4-pin design. Make
sure the holes on the accessory properly engage 3 of those 4 pins and the accessory is flush against the
shaft flange.
3. Make sure the concave side of the large blade washer is facing the accessory. Tighten the cap screw
securely using Allen wrench (c) provided. (See FIG 2)
c
NOTE:
Some accessories shown in FIG 2 are not included, sold separately.
NOTE:
Some accessories, such as a saw blade, may be mounted either straight on the
tool, or at an angle to enhance usability. Always make sure 3 of the 4 pins are engaged
as described in step 2 above.
NOTE:
For maximum sandpaper life, rotate the pad or sandpaper 120 degrees when tip
of sandpaper becomes worn.
WARNING:
seated on the shaft flange.
To Remove Accessories From the Tool,
Always be sure that the tool is switched off and unplugged before
b
DO NOT tighten the cap screw unless the accessory is properly
loosen the cap screw and pull the accessory off the tool.
a
d
FIG 2
9

Publicidad

loading