Pulley Alignment - Porter Cable PXCM601 Manual De Instrucciones

PULLEY ALIGNMENT

To check pulley alignment, remove the belt guard and place a straightedge
(A) against the pump flywheel (See Fig. 9). To correct a pulley misalignment, use
the following procedure. The pulley hub face should be in the same plane as the
flywheel face.
1. Remove the outer belt guard.
2. Loosen the motor mounting bolts.
3. Loosen the set screws on the motor pulley.
Align the motor pulley with the pump flywheel.
4.
5. Re-tighten the motor pulley set screws.
6. Adjust the proper belt tension.
7. Re-tighten the motor mounting bolts.
8. Reinstall the outer belt guard. All moving parts must be guarded.
MAINTENANCE
A
16- ENG
Fig. 9