Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
HAZARDS AND SAFETY PROVISIONS DURING ASSEMBLY
When assembling the appliance, watch out for the following hazards and provide for the counter-
measures indicated below:
► Source of hazard: handling of heavy loads
Where or in which situations
Hazard
does the hazard occur?
Risk of injury
• When the appliance
due to body
moves
overload
HAZARDS AND SAFETY PROVISIONS DURING INSTALLATION AND
COMMISSIONING, ADJUSTMENTS AND PART REPLACEMENT
During appliance installation, commissioning, adjustment and part replacement procedures,
watch out for the following hazards and provide for the countermeasures indicated below:
► Source of hazard: Appliance mechanics
Hazard
Risk of crushing parts
of the body in case of
tip-over or fall of the
appliance
Risk of cutting due
to sharp edges
Risk of crushing parts
of the body in case of
fall of the appliance
6
Where or in which situations
does the hazard occur?
When the appliance is lifted • Pay attention to the cen-
When handling sheet-metal
parts
In case of uneven or sloped
fl oors
Countermeasures
• Use a suitable lifting de-
vice to place the appliance
on the work bench, on the
base
• Adjust the position only if
a suitable number of peo-
ple is available, otherwise
observe the limit values for
lifting and transport
• Comply with the applica-
ble laws on accident pre-
vention for the installation
place
• Wear personal protective
equipment
Countermeasures
tre of gravity
• Avoid collisions
• Pay special care during
this activity
• Wear personal protective
equipment in accordance
with safety regulations
• Comply with the correct
installation requirements
as per section "Installing
the appliance" on page 10
of the installation manual.
SAFETY
Safety device
• Protective gloves
• Protective shoes
• Safety
helmet
(e.g.
for
sus-
pended
loads,
overhead opera-
tions...)
Safety
device
None
None
None
3443260_ut_GB
Publicidad
