Sony SPP-AQ600 Manual De Instrucciones página 37

Transferring a message
After recording each incoming call, the phone transfers the call to a
stored destination number automatically.
To use this function, you need to store the phone number.
Storing the transfer destination number
RING ON/BATT SAVE
Press ( FLASH/REMOTE ),
The REMOTE lamp lights up.
Press (SPEED DIAL/PGM).
Enter the phone number you want to
transfer.
You can enter up to 32 digits
including a tone, and a pause, each
of which is counted as one digit.
Press (SPEED DIAL/PGM).
A long confirmation beep sounds
and the destination number is stored.
Press (FLASH/REMOTE).
The REMOTE lamp goes off.
Notes
• Make sure that the RING ON/BATT SAVE switch is set to RING ON.
* If two minutes have passed during operation, the setting is canceled. Try again
from the beginning.
continued
Using as a telephone answering machine
37™